Holster Open

Holster Closed

Technical Information

Manufacturer:

Polymer80

Model:

PF9SS

Type:

Semiauto

Handedness:

Right

Date:

April 24, 2022

Width Mode:

Wide

1st Pin:

G10

2nd Pin:

G15*

Anchor Washers:

1

Anchor & Shaft:

C9*

Lock Shaft Length:

Short

Shroud Bolt 1:

C7

Shroud Bolt 2:

C11

Ease of Fitting:

7

Notes:

* Install 4 star lock washers between the Anchor and the Side Plate to attain good lock function. NOTE: The outside bottom of the trigger guard is slightly concave. If the Registration Pin in that area is too tight, it will cause a hang up in both the draw and recovery of the PF9SS. Be sure to check for this condition and if found, slightly rotate the Registration Pin to cause a looser contact and then retighten the Pin's screw while holding the Pin in its new position. Test and retighten until a smooth draw and recovery are achieved.